Random good picture Not show

31. In line design minimizes pressure drop across the valve thereby assuring maximum pump performance.

32. The check valve shall utilize single torsion spring design to minimize pressure drop through the assembly.

33. The inlet pipe penetration into the vessel, the pressure drop across any block valves used. upstream of the venting device, and the inlet piping must be considered when determining these losses.

34. Pressure drop for any intermediate flow condition can be determined asin Steps 1 and 2.

35. The experimental results showed that the circumfluent hydro -cyclones with the separating columns had the higher separating efficiency and the lower pressure drop.

36. Experimental results showed that the circumfluent hydrocyclone with a separate column has the highest collection efficiency and the lowest pressure drop.

37. The system measures pressure drop through the material column to determine the onset temperature for the sintering of bituminous rock.

38. The position of the cohesive zone, pressure drop and top gas temperature are affected by both air blast rate and combustion temperature.

39. In this range, the pressure drop increases in proportion to the specific gravity of the mixture.

40. Data regressions show the equation of pressure drop and mean heat transfer coefficient with frontal wind velocity. It offers good help for the optimal design of direct air cooling system.

41. The detector adopts pressure drop principium to measure micro-ohm. Electric circuit structure adopts four-circuit measuring method, eliminate connection evocative error.

41. Sentencedict.com try its best to collect and make good sentences.

42. Flowing status of catalyst bed are guaranteed by adopting reaming air scattering plate and raw material sparger method decided according to the calculation of the pressure drop of reactor bed.

43. In fully spray region, gas flow affects the liquid overflow capacity in the downcomer or conical over flow device, hence affects the pressure drop significantly.

44. Flow area that is 3-5 times that of the equivalent copper tube exchanger and self-cleaning action contribute to low pressure drop and low fouling potential.

45. Advanced construction features of this high pressure drop angle globe valve provide quality and long service life, Class 800 ANSI.

46. As the unit near the gas point, having short connecting pipe, pipeline pressure drop and leakage losses are very small.

47. This paper introduces the basic structure of the tray, calculation of pressure drop, arrangement in scrubber.

48. Based on the analyzing the separation mechanism of wire mesh demister, the formulae for calculating the separation efficiency and pressure drop of wire mesh demister have been proposed.

49. Presents the theoretical model of pressure drop for flexible duct.

50. During filtration, some parameters such as pressure drop over filter andflux of liquid nitrogen were tested.

51. The check valves shall utilize a single torsion spring design to minimize pressure drop through the assembly.

52. The total pressure drop increases with the increase of gas velocity. The liquid hold is affected by the insufflation density.

53. If flow rate is in excess of that specified, turn indicator towards closed position, noting pressure drop and valve setting and determining new flow rates from flow rate chart.

54. Conical degree spiral packing has the advantage in the handling ability, pressure drop and dynamic holdup liquid and so on.

55. The results showed that 88% of the total pressure drop across vasculature from arcuate artery fo glomeruli occurs in the interlobular artery and diameter of preglomerular microvessels.

56. When pulsation amplitude increases, air voidage increases a bit, but bed pressure drop increases.

57. Equations both for calculating frictional pressure drop and heat transfer coefficients of single-phase flow in annulus gap are presented from experimental data.

58. Calculated pressure drop was in good consistency with the actual value of industrial unit in operation.

59. This paper studies pressure drop and build up in flowing well, including conventional and modern analysis method.

60. The main parameters of gas-liquid two-phase flow, such as flow patterns, pressure drop and liquid hold-up, are investigated in this paper.